Seamoon + Kai Lin = bad interaction?
Printed From: Alex Table Tennis - MyTableTennis.NET
Category: Equipment
Forum Name: Equipment
Forum Description: Share your experience and discussions about table tennis equipments.
Moderator: haggisv
Assistant Moderators: position available
URL: http://mytabletennis.net/forum/forum_posts.asp?TID=87697
Printed Date: 04/19/2024 at 5:54pm
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com
Topic: Seamoon + Kai Lin = bad interaction?
Posted By: Lambomets
Subject: Seamoon + Kai Lin = bad interaction?
Date Posted: 02/11/2020 at 3:55am
|
Hello, I used a 40 deg provincial h3 neo 2.15mm with 1 layer seamoon, 1 layer kailin, and 2 layers of rev 3 wbg on acoustic blade. All of these layers were normal size, not too thick. The result was complete mush. Could it be that these two boosters interact badly with each other and damaged the sponge? ------------- Tibhar Stratus Power Wood Adidas p7 Xiom Omega IV Elite |
Replies:
Posted By: ashishsharmaait
Date Posted: 02/11/2020 at 4:29am
Never had a bad experience. A lot of people I know mix Seamoon and Kailin in their magic proportions to get the feeling they want.
|
Lambomets wrote:Posted By: Lambomets
Date Posted: 02/11/2020 at 1:21pm
|
Could it be that my bottle of kai lin is spoiled? It is a few years old. ------------- Tibhar Stratus Power Wood Adidas p7 Xiom Omega IV Elite |
Posted By: chop4ever
Date Posted: 02/12/2020 at 5:46am
Both Kailin and Seamoon have no problem the H3 is. Don't trust the number of degree and never trust "provincial" or "national" ------------- There is no real "pro", "prov" or "NT" H3 in the market. Falco is not a booster |
Posted By: MLfan
Date Posted: 02/12/2020 at 9:25am
| did you add glue before or after oil? |
Posted By: Lambomets
Date Posted: 02/14/2020 at 5:36pm
|
did not add glue before . I dont like to add glue before, makes the rubber feel less crisp ------------- Tibhar Stratus Power Wood Adidas p7 Xiom Omega IV Elite |
Posted By: simon_xuan
Date Posted: 02/16/2020 at 9:30am
|
Probably not booster oil interaction. You might want to wait till the reverse dome turns flatter before gluing and trying. If this is the first time application, the dome should be very obvious. If no dome, then the rubber is overly boosted already. I would say 2 layers at most to avoid over boosting and bubble buildup between top sheet and sponge. ------------- RPB Rocks! BTY Innerforce ZLC Cpen | DHS H3N Blue Sponge | Victas V>15 Extra Feedback: http://mytabletennis.net/forum/forum_posts.asp?TID=36695 |
Posted By: Lambomets
Date Posted: 02/24/2020 at 12:45am
|
Should I remove the protective film from the topsheet of the H3 neo before boosting? By the way, I found the results are very bad if I boost with seamoon without removing the factory primer glue layer. ------------- Tibhar Stratus Power Wood Adidas p7 Xiom Omega IV Elite |