V1 Rubber suggestions?

I'm still a bit hyped after tonight and can't stop thinking about the awesomeness of the loops I cold hit with that V1. I'm going to look for a rubber for it with the following qualities.

1. Tacky or Tacky(ish)
2. Around 38 degree hardness
3. Low throw, but slightly higher than H2
4. Able to stand being hit hard with a hard blade without bottoming out

The only complaints I have about the Globe 999-n I stuck on it are, a little too springy in close (it's 40 degree and not tacky like H2 so it's faster on soft shots), it doesn't generate as much spin as H2 and it bottomed badly out a couple of times (not often). Otherwise I found the height it throws perfect for the blade. I'm thinking of TG3 although I've never had a serious go with that and never on a weapon of a blade like this so I'm a bit unsure. All suggestions welcome:) especailly if someone knows of a 729 rubber with the above qualities

Since this seems to be a hard blade ( rather low throw ), a hard rubber ( often lower throw ) would make this combination maybe too low throw. Hence softer rubbers recommended. I d also try TG3, but the non-#21 to make sure it s not going too soft.

H2 Neo..

nicefrog,

If you think WLQ used this V-1, try to find out what he used on this blade. You can save a lot of time and money.

Where did you buy this Stiga ?
They do not sell it in the U.S.A.

Give it a go anyway.. 

He's got to be using one of the 4 main DHS rubbers, almost for sure either TG3/H3 _maybe_ H2 and he's not using anything with a blue sponge on it. So at the worst it will cost 60$ to have the same(ish) FH rubber, at least the same topsheet :). If he's still using it at the next tournament maybe someone will get a picture

nicefrog,

Did you feel a carbon ping with the V-1 as the other person stated ?

I was going to order blue H2, but I dont wanna pay 30 dollars for it :(

hey, I'm not even kidding when I say lets do that

hah Whale powa here we come!, I will miss my lovely sheet of H2 it's lucky they are cheap for me :)