my rubber hasnt domed
Printed From: Alex Table Tennis - MyTableTennis.NET
Category: Equipment
Forum Name: Equipment
Forum Description: Share your experience and discussions about table tennis equipments.
Moderator: haggisv
Assistant Moderators: position available
URL: http://mytabletennis.net/forum/forum_posts.asp?TID=90456
Printed Date: 04/19/2024 at 7:42pm
Software Version: Web Wiz Forums 12.01 - http://www.webwizforums.com
Topic: my rubber hasnt domed
Posted By: Willj0320
Subject: my rubber hasnt domed
Date Posted: 07/16/2021 at 6:55pm
  Hi guys im in the boosting process for my hurricane 3 NEOS i started tuesday by puting on the first layer on, yesterday i put the second layer on my question is why hasnt my rubber domed as its been 24 hours since I put the second layer. I will attach photos do i add another layer ? i have a big tourneyment next week i would love know if i doing this right Thanks, |
Replies:
Posted By: Kolev
Date Posted: 07/16/2021 at 9:49pm
Strange. All my NEO's get a curl even if they just catch a scent of a booster near by.  Btw the only booster I use iis FTL and one layer is usually enough to dome the rubber.....but frankly I remember one rubber which didn't react at all because it was too old. ------------- Hallmark Carbon Extreme (x3) FH: D05/G1/RX BH: Z2/D64/Ω7Pro |
Posted By: GrayGhost
Date Posted: 07/16/2021 at 10:24pm
| I found 2 layers with Seamoon don't cause much of dome, especially with commercial. The Blue Sponge domes slightly... 3 layers turns it into a tunnel and had to wait 3 days before the rubber flattened out enough to glue to the blade. |
Posted By: gekogark1212
Date Posted: 07/17/2021 at 5:17am
|
Looks like a lot of old glue on it. The booster is probably not reaching the sponge. Try cleaning it off first and then reboosting ------------- (\__/) (='.'=) But there's no sense crying over every mistake, (")_(") You just keep on trying till you run out of cake. |
Posted By: Willj0320
Date Posted: 07/17/2021 at 3:58pm
|
thats the updated layer of glue |
Posted By: Zwill
Date Posted: 07/17/2021 at 4:29pm
|
When you took it off did it have a reverse dome? I use H3N or Battle 2 on my forehand and when I take them off they have a pretty severe reverese dome. When I apply some baby oil or seamoon they get back being flat or dome slightly but that's normal. I think H3N factory boost and the pre-glue is really top notch and doesn't need any additional so if you're flat or slightly domed that's good to go.
|